Arduino pro mini 3.3 не прошиватеся.

Нет ответов
AlexOs
Offline
Зарегистрирован: 28.07.2017

После случайной прошивки arduino pro mini 3.3v скетчем с установленным настройками на arduino pro mini 5v, ардуинка больше не прошивается. 

Ошибка во время загрузки: 

avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x1c
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x07
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0xc7
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x1c
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0xc7
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x1c
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0xc7
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x1c
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x87
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x1c